Highly active lanthanum doped nickel anode for solid oxide fuel cells directly fuelled with methane

Lanthanum doped nickel and YSZ composite anode (LaNi–YSZ) exhibited a greatly reduced polarization resistance and high performance for electrochemical oxidation of hydrogen and methane, which resulted from a fine anode structure with a high dispersion of nickel catalyst and a high catalytic activity towards methane.     

对硝基苯偶氮2-羟基萘-3-甲酰烷基胺系聚丙烯纤维用红色染料的合成及应用

本文将2,3-酸在甲苯溶剂中用氯化亚砜酰氯化合成2-羟基萘-3-甲酰氯,将其分别和正丁胺、正辛胺、正十二胺和正十八胺反应制得4种不同碳链长度的2-羟基萘-3-甲酰烷基胺,用对硝基苯胺重氮盐与其偶合分别制得了对硝基苯偶氮2-羟基萘-3-甲酰正丁胺、对硝基苯偶氮2-羟基萘-3-甲酰正辛胺、对硝基苯偶氮2-羟基萘-3-甲酰正十二胺和对硝基苯偶氮2-羟基萘-3-甲酰正十八胺系聚丙烯纤维用红色染料。熔点分别为189.8℃、96.2℃、115.8℃和108.1℃;热分解点分别为273.1℃、216.0℃、258.0℃和221.0℃;最大吸收波长分别为515.8nm、516.8nm、513.6nm和514.2nm。在染色条件下,4支染料在聚丙烯纤维上的上染率分别37.6％、41.8％、42.4％和44.7％。     

B2O3/TiO2-ZrO2催化剂上环己酮肟的气相Beckmann重排反应

用共沉淀法制备了TiO2-ZrO2复合氧化物载体，BET，DTA，XRD表征结果表明，该复合载体具有较大的比表面和较好的热稳定性，对于环己酮肟气相Beckmann重排反应制己内酰胺，用复合载体制备的B2O3／TiO2-ZrO2催化剂，比分别以TiO2,ZrO2为载体所制备的B2O3/TiO2和B2O3／ZrO2催化剂具有更高的活性和选择性，实验表明，催化剂表面中等强度的酸位是环己酮肟气相Beckmann重排反应的有效活性中心。     

中国软磁铁氧体用氧化铁

介绍了中国软磁铁氧体用氧化铁的发展历史和现状，预测了未来的市场需求，并探讨了氧化铁的应用技术问题。     

Dynamics of hydrated iron(II) cations in nafion polymer membranes

Mössbauer studies of Fe²⁺ in water-soaked nafion polymer membranes in the temperature range between 90 K and 250 K have been performed. Above a critical temperature (～ 180 K) the spectra exhibit both elastic narrow absorption lines and quasielastic broad lines. These spectra are typical of bounded diffusion phenomena observed by Mössbauer spectroscopy in macromolecular systems like haemoglobin, myoglobin and ferritin. Similar spectral shapes have been observed by quasielastic neutron scattering from water in nafion membranes. Within 50 K above the critical temperature the total Mössbauer absorption area decreases by an order of magnitude whereas the narrow absorption line decreases by two orders of magnitude. The results are interpreted in terms of bounded diffusive motion of the iron. Using a model based on overdamped harmonically bound Brownian motion, the essential parameters of the iron motion can be derived as a function of temperature. The iron motion most probably reflects the motion of a large Fe²⁺ complex, e.g. Fe(H₂O)²⁺₆, which is attached to the polymer side chains via the sulphonic group.     

Cold Gelation of β-lactoglobulin in the Presence of Iron

ABSTRACT: To protect and transport iron, we investigated the trapping properties of a network formed from β-lactoglobulin. We studied the influence of different parameters—pH, iron, and protein concentrations—on gel properties (optical and mechanical properties, WHC, and microstructure). For all conditions tested, the results show the formation of a cold gel in the presence of iron. The mechanical properties reveal that the elastic behavior and the strength of rupture increase with higher protein concentrations and decrease with higher iron concentrations. The water-holding capacity is high for low iron concentrations. The microstructure shows that, at low iron/protein ratios, a homogeneous filamentous network is obtained whereas, at high iron/protein ratios, more random aggregated particles are present.     

Comparative hall measurements on wet- and dry-oxidized 4H-SiC MOSFETs

Hall measurements have been used to compare the properties of 4H-SiC inversion-mode MOSFETs with “wet” and “dry” gate oxides. While the field-effect mobilities were approximately 3–5 cm²/Vs, the Hall mobilities in 4H-SiC MOSFETs in the wet and dry oxide samples were approximately 70–80 cm²/Vs. The dry-oxidized metal oxide semiconductor field effect transistors (MOSFETs) had a higher transconductance, improved threshold voltage, improved subthreshold slope, and a higher inversion carrier concentration compared to the wet-oxidized MOSFETs. The difference in characteristics between the wet- and the dry-oxidized MOSFETs is attributed to the larger fixed oxide charge in the dry oxide sample and a higher interface trap density in the wet oxide sample.     

Influence of load and speed on wear characteristics of grey cast iron in dry sliding — selection for minimum wear

The wear of grey cast iron in dry sliding conditions has been studied with the aims of (1) finding the influence of working conditions on the wear rate, and (2) determining the region of speed and load where low wear is accomplished. Grey cast iron with flake and nodular graphite was submitted to investigation using a pin-on-disc machine. The results indicate that the flake graphite cast iron is more suitable for applications at speeds greater than 4 m s⁻¹ and lower loads, while nodular cast iron has greater wear resistance at lower speeds in the range of loads investigated - from 50 N cm⁻² to 200 N cm⁻²     

Influence of heat transfer on anodic oxidation of aluminium

The influence of convective heat transfer on constant current density anodizing of aluminium in sulfuric acid has been examined in a wall-jet electrode reactor. The uniformity of the anodic film thickness is related to the local electrode temperature distribution, which is dependent on the convection. The higher the local temperature, the greater the local oxide thickness. An increased local temperature enhances local field assisted oxide dissolution at the pore bases, and consequently acts to increase the local current density. At relatively high current densities, local features develop on the electrode surface, accompanied by high initial, local temperature rises. The relevance of such local features, limiting useful oxide growth, is considered further.     

Sol-gel processing: A versatile concept for special glasses and ceramics

The various parameters related to sol-gel processing are discussed with special reference to those which usually attract less attention but depending on the final product in mind, can play important roles. The versatility of the sol-gel technique in materials preparation is demonstrated by discussing the various products developed at the author’s laboratory by using this processing method.